alex9ufo 聰明人求知心切: 實驗1-1 RFID RC522 Interfacing with ESP32

2023年7月10日星期一

實驗1-1 RFID RC522 Interfacing with ESP32

RFID RC522 Interfacing with ESP32

 *             MFRC522      ESP32      

 *             Reader/PCD             

 * Signal      Pin          Pin       

 * ----------------------------------

 * RST/Reset   RST          GPIO27      

 * SPI SS      SDA(SS)      GPIO5            

 * SPI MOSI    MOSI         GPIO23          

 * SPI MISO    MISO         GPIO19           

 * SPI SCK     SCK          GPIO18        

 Arduino 程式

//=================================================
/*
 *             MFRC522      ESP32      
 *             Reader/PCD             
 * Signal      Pin          Pin       
 * ----------------------------------
 * RST/Reset   RST          GPIO27      
 * SPI SS      SDA(SS)      GPIO5            
 * SPI MOSI    MOSI         GPIO23          
 * SPI MISO    MISO         GPIO19           
 * SPI SCK     SCK          GPIO18    */    
//=================================================
#include <SPI.h>
#include <MFRC522.h>

#define SS_PIN  5  // ESP32 pin GIOP5 
#define RST_PIN 27 // ESP32 pin GIOP27 
 
MFRC522 rfid(SS_PIN, RST_PIN); // Instance of the class

MFRC522::MIFARE_Key key; 

// Init array that will store new NUID 
byte nuidPICC[4];
//=================================================
/**
 * Helper routine to dump a byte array as hex values to Serial. 
 */
void printHex(byte *buffer, byte bufferSize) {
  for (byte i = 0; i < bufferSize; i++) {
    Serial.print(buffer[i] < 0x10 ? " 0" : " ");
    Serial.print(buffer[i], HEX);
  }
}
//=================================================
/**
 * Helper routine to dump a byte array as dec values to Serial.
 */
void printDec(byte *buffer, byte bufferSize) {
  for (byte i = 0; i < bufferSize; i++) {
    Serial.print(buffer[i] < 0x10 ? " 0" : " ");
    Serial.print(buffer[i], DEC);
  }
}
//=================================================
void setup() { 
  Serial.begin(115200);
  SPI.begin(); // Init SPI bus
  rfid.PCD_Init(); // Init MFRC522 

  for (byte i = 0; i < 6; i++) {
    key.keyByte[i] = 0xFF;
  }

  Serial.println(F("This code scan the MIFARE Classsic NUID."));
  Serial.print(F("Using the following key:"));
  printHex(key.keyByte, MFRC522::MF_KEY_SIZE);
}
//================================================= 
void loop() {

  // Reset the loop if no new card present on the sensor/reader. This saves the entire process when idle.
  if ( ! rfid.PICC_IsNewCardPresent())
    return;

  // Verify if the NUID has been readed
  if ( ! rfid.PICC_ReadCardSerial())
    return;

  Serial.print(F("PICC type: "));
  MFRC522::PICC_Type piccType = rfid.PICC_GetType(rfid.uid.sak);
  Serial.println(rfid.PICC_GetTypeName(piccType));

  // Check is the PICC of Classic MIFARE type
  if (piccType != MFRC522::PICC_TYPE_MIFARE_MINI && 
    piccType != MFRC522::PICC_TYPE_MIFARE_1K &&
    piccType != MFRC522::PICC_TYPE_MIFARE_4K) {
    Serial.println(F("Your tag is not of type MIFARE Classic."));
    return;
  }

  if (rfid.uid.uidByte[0] != nuidPICC[0] || 
    rfid.uid.uidByte[1] != nuidPICC[1] || 
    rfid.uid.uidByte[2] != nuidPICC[2] || 
    rfid.uid.uidByte[3] != nuidPICC[3] ) {
    Serial.println(F("A new card has been detected."));

    // Store NUID into nuidPICC array
    for (byte i = 0; i < 4; i++) {
      nuidPICC[i] = rfid.uid.uidByte[i];
    }
   
    Serial.println(F("The NUID tag is:"));
    Serial.print(F("In hex: "));
    printHex(rfid.uid.uidByte, rfid.uid.size);
    Serial.println();
    Serial.print(F("In dec: "));
    printDec(rfid.uid.uidByte, rfid.uid.size);
    Serial.println();
  }
  else Serial.println(F("Card read previously."));

  // Halt PICC
  rfid.PICC_HaltA();

  // Stop encryption on PCD
  rfid.PCD_StopCrypto1();
}

//=================================================