28BYJ-48 步進馬達實驗 (二相激磁)

28BYJ-48 步進馬達實驗 (二相激磁)

留意 順序 1-3-2-4  對應 接腳 6, 8, 7, 9
// here in the sequence 1-3-2-4 for proper sequencing
Stepper small_stepper(STEPS_PER_MOTOR_REVOLUTION, 6, 8, 7, 9);

5V Stepper Motors
You will need a stepper library, but there is one built into Arduino, so no installation should be needed.

These steppers normally have 4096 steps per revolution, but the built in stepper library works in
4 step sequence vs the 8 step sequence that it would expect, so we need to consider it as 2048, though you might find this is not completely accurate either and you may need to tweak code.

The code expects this pinout - you may modify as necessary:
IN1 --> 8
​IN2 --> 9
​IN3 --> 10
​IN4 --> 11
5-12V+ -->5V
​Gnd- --> Gnd

28BYJ-48 步進馬達實驗 (二相激磁)

/*-----( Import needed libraries )-----*/
#include <Stepper.h>

/*-----( Declare Constants, Pin Numbers )-----*/
//---( Number of steps per revolution of INTERNAL motor in 4-step mode )---
#define STEPS_PER_MOTOR_REVOLUTION 32

//---( Steps per OUTPUT SHAFT of gear reduction )---
#define STEPS_PER_OUTPUT_REVOLUTION 32 * 64  //2048


/*-----( Declare objects )-----*/
// create an instance of the stepper class, specifying
// the number of steps of the motor and the pins it's
// attached to

//The pin connections need to be 4 pins connected
// to Motor Driver In1, In2, In3, In4  and then the pins entered
// here in the sequence 1-3-2-4 for proper sequencing
Stepper small_stepper(STEPS_PER_MOTOR_REVOLUTION, 6, 8, 7, 9);  // 1-3-2-4 for proper sequencing

/*-----( Declare Variables )-----*/
int  Steps2Take;

void setup()   /*----( SETUP: RUNS ONCE )----*/
{
// Nothing  (Stepper Library sets pins as outputs)
}/*--(end setup )---*/

void loop()   /*----( LOOP: RUNS CONSTANTLY )----*/
{
  Steps2Take  =  STEPS_PER_OUTPUT_REVOLUTION ;  // Rotate CW 1 turn
  small_stepper.setSpeed(250);
  small_stepper.step(Steps2Take);
  delay(1000);

  Steps2Take  =  - STEPS_PER_OUTPUT_REVOLUTION;  // Rotate CCW 1 turn
  small_stepper.setSpeed(500);  // 700 a good max speed??
  small_stepper.step(Steps2Take);
  delay(2000);

}/* --(end main loop )-- */

/* ( THE END ) */