ESP8266 ESP-12 Test Board---1

*實作注意事項:

(1)ESP8266模塊必須使用+3.3V，雖然板上Power端有外接一電池盒(可內置1.5V AA Size 3顆)，但由於板載穩壓電路內置7333-1(3.3V低壓差穩壓IC)。所以在實際測試時，可外接電池盒4.5V供電使用。

(2)板上USB2Serial Pin處符號RXD插針，實際是連接至其上方ESP8266模塊中TXD接腳。

(3)板上USB2Serial Pin處符號TXD插針，實際是連接至其上方ESP8266模塊中RXD接腳。

(4) Connect the USB-TTL to pc and upload sketch to ESP-12

      Note: GPIO0 should be LOW  ,  CH_PD and RST should be HIGH for first time flashing the board

(5) 需按Reset 或是 9V轉3.3V 5V的 POWER SW 才能進入  upload sketch 上傳模式

(6)  GPIO0 上傳後拔除接地 

/*
 ESP8266 Read input from GPIO14, write to on-board rgb_LED
=================================================================
Connect the USB-TTL to pc and upload sketch to ESP-12
Note: GPIO0 should be LOW
      CH_PD and RST should be HIGH for first time flashing the board

GPIO0 should be LOW when uploading sketches
Remember use a 3.3V USB-TTL
connect RX of board to TX of usb and TX of board to RX
SKETCH:
edit auth code, ssid and pass
=================================================================
*/

int pin_Button12 = 12;  //GPIO12  RGBLED
int pin_Button13 = 13;  //GPIO13
int pin_Button14 = 14;  //GPIO14  RGBLED
int pin_Button15 = 15;  //GPIO15  RGBLED

void setup() {

  pinMode(pin_Button12, OUTPUT);
  pinMode(pin_Button13, OUTPUT);
  pinMode(pin_Button15, OUTPUT);

  pinMode(pin_Button14, INPUT_PULLUP);
}

void loop() {

  if(digitalRead(pin_Button14)){
    for (byte i=0;i<=5;i++) {
      digitalWrite(pin_Button12, HIGH);   //LED OFF
      digitalWrite(pin_Button13, HIGH);   //LED OFF
      digitalWrite(pin_Button15, HIGH);   //LED OFF
      delay(500);
      digitalWrite(pin_Button12, LOW);   //LED ON
      digitalWrite(pin_Button13, LOW);   //LED ON
      digitalWrite(pin_Button15, LOW);   //LED ON
      delay(500);
      }
   }
  else {
    digitalWrite(pin_Button12, LOW);   //LED ON
    digitalWrite(pin_Button13, LOW);   //LED ON
    digitalWrite(pin_Button15, LOW);   //LED ON
   }
}


參考
1)
http://yptsai7.wixsite.com/home/single-post/2015/06/17/ESP12-Test-Board-%E8%88%87-Blynk-App-%E6%87%89%E7%94%A82ESP12-Test-Board%E7%A1%AC%E9%AB%94%E4%BB%8B%E7%B4%B9

2)
http://www.instructables.com/id/ESP8266-ESP-12Standalone-Blynk-101/step1/The-Blynk-app/