- Division
- Division is another example of combining simple logic function to make a more complex circuit. Note that the method shown below ignores the divide-by-0 condition. (see also Multipliers and dividers)
- Algorithm 1: attempt subtraction
- In calculating A / B, the divisor B is repeatedly subtracted from the digits of the dividend (A), after being multiplied either with ’1′ or with ’0′. This multiplication bit (’1′ or ’0′) is selected for each subtraction step in such a manner that the subtraction result is not negative. The division result is composed from all the successive multiplication bits while the remainder is the result of the last subtraction step.
- This algorithm can be implemented by a series of subtractors. Each subtractor calculates the difference between two input numbers, but if the result is negative the operation is canceled and replaced with a subtraction of zero.
- Each divider module:
- contains a 1-bit subtractor with the usual inputs A, B and Li and outputs D and Lo.
- the output select (OS) signal selects between bit X and A-B. The signal is connected to the loan output (Lo) of the most significant 1-bit subtractor.
- 0, means subtraction result was positive → D’ = D.
- 1, means subtraction result was negative → D’ = X.
- Inside each divider cell the OS signal selects between bitA and A-B.
- The outputs can be expressed as a function of the inputs as in:
- The complete division can therefore be implemented by a matrix of divider cells connected on rows and columns as shown in figure on the right.
- Each row performs one multiplication-and-subtraction cycle where the multiplication bit is supplied by the NOT logic gate at the end of each row. (also see “Combinational arithmetic“)
- The number of gates increases with the square width of the numbers being divided. This limits its use to designs where bit-width is relatively small, typically around 16 bits or below.
2013年12月30日 星期一
Division
訂閱:
張貼留言 (Atom)
2024_09 作業3 以Node-Red 為主
2024_09 作業3 (以Node-Red 為主 Arduino 可能需要配合修改 ) Arduino 可能需要修改的部分 1)mqtt broker 2) 主題Topic (發行 接收) 3) WIFI ssid , password const char br...
-
python pip 不是内部或外部命令 -- 解決方法 要安裝 Pyqt5 1. 首先,開啟命令提示字元。 2. 輸入 pip3 install pyqt5 好像不能執行 ! ! 錯誤顯示 : ‘ pip3 ’ 不是內部或外部命令、可執行的程式或批...
-
課程講義 下載 11/20 1) PPT 下載 + 程式下載 http://www.mediafire.com/file/cru4py7e8pptfda/106%E5%8B%A4%E7%9B%8A2-1.rar 11/27 2) PPT 下載...
-
• 認 識 PreFix、InFix、PostFix PreFix(前序式):* + 1 2 + 3 4 InFix(中序式): (1+2)*(3+4) PostFix(後序式):1 2 + 3 4 + * 後 序式的運算 例如: 運算時由 後序式的...
沒有留言:
張貼留言